搜索热:裂纹 硫酸
扫一扫 加微信
首页 > 期刊论文 > 论文摘要
高温时效对P92耐热钢持久性能的影响
          
Effects of High Temperature Aging on Creep-Rupture Property of P92 Heat-Resistant Steel

摘    要
将P92耐热钢在650℃分别时效600,1 200 h后,再在170 MPa,650℃下进行单轴拉伸蠕变试验,观察了时效和蠕变断裂后试验钢的显微组织,分析了其持久性能。结果表明:时效后试验钢中的板条马氏体发生粗化,组织中析出了Laves相,且时效时间越长,Laves相的数量越多、直径越大;蠕变断裂后,近断口组织中的板条马氏体均变为等轴状;时效后试验钢的蠕变断裂寿命缩短但蠕变断裂应变提高,持久性能下降;时效前后试验钢在蠕变过程中均发生了韧性断裂,时效后蠕变断口上的韧窝较小且较浅。
标    签 高温时效   持久性能   P92耐热钢   high temperature aging   creep-rupture property   P92 heat-resistant steel  
 
Abstract
P92 heat-resistant steel was aged at 650℃ for 600, 1 200 h, respectively, and then subjected to uniaxial tensile creep test at 170 MPa and 650℃. The microstructures of the tested steel after aging and creep rupture were observed and the creep-rupture property was analyzed. The results show that after aging, the lath martensite in the tested steel was coarsened, and Laves phase precipitated in the structure. The longer the aging time, the larger the number and the diameter of the Laves phase. After creep rupture, the lath martensite in the structure near fracture became equiaxed. After aging, the creep rupture life of the tested steel was shortened but the creep rupture strain increased, indicating the decrease in the creep-rupture property. The tested steel before and after aging both fractured in ductile during creep, and the dimples on the creep rupture fracture after aging were relatively small and relatively shallow.

中图分类号 TG142.1   DOI 10.11973/jxgccl201906006

 
  中国光学期刊网论文下载说明


所属栏目 材料性能及应用

基金项目 国家自然科学基金资助项目(51605330,11602169)

收稿日期 2018/5/2

修改稿日期 2019/5/15

网络出版日期

作者单位点击查看

备注韩红光(1989-),男,河北保定人,硕士研究生

引用该论文: HAN Hongguang,SHEN Junjie,XIE Jiaxing. Effects of High Temperature Aging on Creep-Rupture Property of P92 Heat-Resistant Steel[J]. Materials for mechancial engineering, 2019, 43(6): 28~32
韩红光,申俊杰,解家兴. 高温时效对P92耐热钢持久性能的影响[J]. 机械工程材料, 2019, 43(6): 28~32


论文评价
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
分享论文
分享到新浪微博 分享到腾讯微博 分享到人人网 分享到 Google Reader 分享到百度搜藏分享到Twitter

参考文献
【1】戴长清, 田富强, 轩福贞. 超超临界锅炉管道用T92/P92钢蠕变性能[J]. 压力容器, 2010, 27(3):40-45.
 
【2】聂铭, 张健, 黄丰, 等. T/P92耐热钢研究进展[J]. 金属热处理, 2013,38(11):40-44.
 
【3】YAN W, WANG W, SHAN Y Y, et al. Microstructural stability of 9-12%Cr ferrite/martensite heat-resistant steels[J]. Frontiers of Materials Science, 2013, 7(1):1-27.
 
【4】PEŠI AČG KA J, KUŽEL R, DRONHOFER A, et al. The evolution of dislocation density during heat treatment and creep of tempered martensite ferritic steels[J]. Acta Materialia, 2003, 51(16):4847-4862.
 
【5】DANIELSEN H K, HALD J. Behaviour of Z phase in 9-12%Cr steels[J]. Energy Materials, 2006, 1(1):49-57.
 
【6】李斌, 徐晓伟. T/P92钢的时效组织与性能[J]. 金属热处理, 2014, 39(12):110-113.
 
【7】张红军, 周荣灿, 唐丽英, 等. P92钢650℃时效的组织性能研究[J]. 中国电机工程学报, 2009, 29(增刊1):174-177.
 
【8】耿鲁阳, 郭晓峰, 巩建鸣, 等. 国产和进口P92耐热钢显微组织、拉伸和蠕变性能的对比[J]. 机械工程材料, 2014, 38(1):68-73.
 
【9】赵勇桃, 董俊慧, 张韶慧, 等. P92钢高温拉伸断口形貌的研究[J]. 材料工程, 2015, 43(4):85-91.
 
【10】刘福广, 李太江, 梁军, 等. 高温时效对P92钢焊接接头显微组织和力学性能的影响[J]. 中国电机工程学报, 2011, 31(14):121-126.
 
相关信息
   标题 相关频次
 Super304H钢焊接接头的时效组织及其持久性能
 3
 NF709R耐热钢高温长时时效后的组织和性能
 2
 固溶处理工艺对HR3C奥氏体耐热钢组织和性能的影响
 2
 国产和进口P92耐热钢显微组织、拉伸和蠕变性能的对比
 2
 基于电阻法的金属材料损伤表征研究现状
 2
 冷变形对Sanicro 25奥氏体耐热钢组织和性能的影响
 2
 铌含量对HR3C钢在高温时效过程中显微组织演变的影响
 2
 BSTC T1504金属材料持久蠕变试验能力验证活动报名倒计时:名额有限,报名从速!
 1
 T91钢在650 ℃时效过程中析出相的变化
 1
 δ相对激光选区熔化成形GH4169合金持久性能的影响
 1
 高温时效Super304H耐热钢的组织、硬度及其关系模型
 1
 热等静压工艺对选区激光熔化成形Hastelloy X合金持久性能的影响
 1
 一种第二代镍基单晶高温合金固溶时效处理工艺的确定
 1
 运行15 万h后F12钢主蒸汽管道剩余寿命的预测与试验验证
 1