Effect of Annealing Temperature on Microstructure and Tensile Properties of TRIP 780 Steels with Different Compositions
![](/skin/Gold/line_sep1.gif)
摘 要
借助光学显微镜、扫描电镜、X射线衍射仪和拉伸试验机等检测手段, 研究了退火温度对含钛和不含钛冷轧低碳硅锰系TRIP钢组织和拉伸性能的影响。结果表明: 随着退火温度的升高, 两种试验钢中铁素体含量减少、晶粒尺寸减小, 贝氏体及马氏体含量有所增加, 残余奥氏体含量先降后升; 含钛钢残余奥氏体中的碳含量随退火温度的升高呈略微增加的趋势, 不含钛钢的则呈现先降低后升高的变化规律; 含钛钢在820 ℃退火后的拉伸性能可满足要求。
![](flash/relate.gif)
![](flash/relate.gif)
![](flash/relate.gif)
![](flash/relate.gif)
![](flash/relate.gif)
![](flash/relate.gif)
![](flash/relate.gif)
![](flash/relate.gif)
![](flash/relate.gif)
![](flash/relate.gif)
Abstract
The effects of annealing temperature on microstructure and tensile properties of cold rolled low carbon Si-Mn TRIP steels with titanium and without titanium were studied by means of optical microscopy, scanning electron microscopy, X-ray diffraction and tensile testing. The results show that, in the tested steel, the ferrite content and grain size decreased, bainite and martensite contents increased and residual austenite content decreased first and then increased with the increase of annealing temperature. The carbon content in retained austenite increased a little in the steel with Ti, and decreased first and then increased in the steel without Ti. The tensile properties of the steel with Ti met the requirement after annealing at 820 ℃.
中图分类号 TG142
所属栏目 试验研究
基金项目
收稿日期 2012/1/26
修改稿日期 2012/11/8
网络出版日期
![](/skin/blank.gif)
作者单位点击查看
![](/skin/blank.gif)
备注刘刚伟(1986-), 男, 陕西渭南人, 硕士研究生。
引用该论文: LIU Gang-wei,LIU Qing-you,JIA Shu-jun,CAO Jian-chun,LI Shan-shan. Effect of Annealing Temperature on Microstructure and Tensile Properties of TRIP 780 Steels with Different Compositions[J]. Materials for mechancial engineering, 2013, 37(4): 17~21
刘刚伟,刘清友,贾书君,曹建春,李珊珊. 退火温度对不同成分TRIP780钢组织与拉伸性能的影响[J]. 机械工程材料, 2013, 37(4): 17~21
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
![请选择您对本文的评价](/skin/Gold/evaluation/ev_01.gif)
![您认为本文一无是处!](/skin/Gold/evaluation/ev_02.gif)
![您认为本文较差,没啥用!](/skin/Gold/evaluation/ev_03.gif)
![您认为本文一般,没太大参考价值](/skin/Gold/evaluation/ev_04.gif)
![您认为本文尚可,值得参考](/skin/Gold/evaluation/ev_05.gif)
![您认为本文很好,值得推荐](/skin/Gold/evaluation/ev_06.gif)
参考文献
【1】张迎晖, 康永林, 于浩, 等.薄板坯连铸连轧工艺制备TRIP钢的力学性能与组织[J].北京科技大学学报, 2005, 27(6): 688-691.
【2】USHILDA K. Recent developments in steel sheets[J].Scandinavian Metal, 1999, 28: 33-39.
【3】江海涛, 唐荻. 含铌TRIP钢连续退火后的组织性能及强化机理[J].北京科技大学学报, 2010, 32(2): 201-206.
【4】江海涛, 唐荻, 刘强 , 等. TRIP钢中残余奥氏体及其稳定性的研究[J].钢铁, 2007, 42(8): 60-61.
【5】LEE C G, KIM S J, LEE T H, et al. Effects of volume fraction and stability of retained austenite on formability in 0.1C-1.55Si-1.5Mn-0.5Cu TRIP-aided cold-rolled steel sheet[J].Materials Science and Engineering, 2004, 371(1/2): 16-23.
【6】JING C N, WANG Z C, HAN F T. Research progress of the influenceing factors on transformation induced plasticity[J]. Metal Heat Treatment, 2005, 30(2): 26-30.
【7】JIMENEZ-MELERO E, DIJK N H, ZHAO L, et al.Characterization of individual retained grains and their stability in low-alloyed TRIP steels[J].Acta Materialia, 2007, 55(12): 6713-6723.
【8】景财年.CMnAl-TRIP钢组织性能的研究[D].济南: 山东大学, 2007.
【2】USHILDA K. Recent developments in steel sheets[J].Scandinavian Metal, 1999, 28: 33-39.
【3】江海涛, 唐荻. 含铌TRIP钢连续退火后的组织性能及强化机理[J].北京科技大学学报, 2010, 32(2): 201-206.
【4】江海涛, 唐荻, 刘强 , 等. TRIP钢中残余奥氏体及其稳定性的研究[J].钢铁, 2007, 42(8): 60-61.
【5】LEE C G, KIM S J, LEE T H, et al. Effects of volume fraction and stability of retained austenite on formability in 0.1C-1.55Si-1.5Mn-0.5Cu TRIP-aided cold-rolled steel sheet[J].Materials Science and Engineering, 2004, 371(1/2): 16-23.
【6】JING C N, WANG Z C, HAN F T. Research progress of the influenceing factors on transformation induced plasticity[J]. Metal Heat Treatment, 2005, 30(2): 26-30.
【7】JIMENEZ-MELERO E, DIJK N H, ZHAO L, et al.Characterization of individual retained grains and their stability in low-alloyed TRIP steels[J].Acta Materialia, 2007, 55(12): 6713-6723.
【8】景财年.CMnAl-TRIP钢组织性能的研究[D].济南: 山东大学, 2007.
相关信息